What is your backer amount?

How much did you guys give to Peachy Printer as a Backer either through Kickstarter or Indigogo?

Feel free to share.

Ed

Well i didnt back them up yet,

At the speed they are and will improve this machine its just not realy smart yet in my stand point to buy one yet,

Of course without backers they wont get any money to improve there product, But from a consumer stand point its just, its to early to realy call it a succesfull printer yet,

Great idea and such, but i will rather wait so the starter problems are out ^^
But ye they seem to work great on this device and seem to work with passion at this device.

I decided to back it at the $100 pledge. Only 1 of these remain.

I backed both campaign one each (99 + 100) - although I think it is fanciful and possibly a vapour ware at the moment but I hope with the amount of money they will be getting - it could possibly turned into something.

Backed it with $150 at kickstarter to get a full kit.

I backed at the pro level.

i backed at the beta tester level ($600). im really looking forward to it

I also did a beta test level and am really looking forward to sitting down and figuring out the simplest/most reliable way to set up and align the baby, and am thinking about using some small tubs of approx 7 litres for the development, and near the end will probably go to about 35 litres or perhaps larger

Pro backer here.

Aww :( Not a pro.. Just a printer and Stands/containers = $170'ish

Beta via KS here.

via Indiegogo
Printer
Telescope thing with reservoir
1 L Resin
500 wiggle Resin

Beta tester via Indiegogo Backerkit