Printer Built, Whats Next? (Calibrations)
Hey Guys
The printer I inherited has now been completely rewired, and is ready to be calibrated, However my knowledge of this step is next to none :(
What are the steps i need to take to ensure that I don't write the printer of at first print? I'm guessing this would require maximum and minimum limits as well as Datums to be set.
The printer is a MendelMax 1.5 running Ramps 1.4 board and Marlin config.
So really what im asking is how do i go about getting the printer ready to print?
Also what printing software do you guys favor? As there area many different programs i have seen
Many many thanks in advance
Ramjam