1 Attachment(s)
How can i get a large print to stick???
I'm done trouble shooting and out of ideas. Here is the rundown.... I've adjusted the print bed to between 90 - 120 C. I've also used hairspray and that did work pretty well for the smaller prints. As you can see from my pic this print will not stay attached. This is at least the 12th try. On this print I also tried a generous amount of hairspray but no luck. I'm looking for troubleshooting ideas, thx.
Attachment 8712
Founder & CEO - Divide By Zero Technologies Pvt. Ltd.
KISSlicer has some nice features:
Easy selection between fast and precise
The printer settings contain one set of parameters for a fast speed and another set for precise operation. Using a slider you can select between those without having to change any of the parameters.
Raft
Select between a raft or a brim and select how much bigger the fast must be than your object.
Support with a 'sheath' given a more stronger support that does not break away during printing. The support also gets more dense when the object is reached (vertically) forming a kind of raft - this gives a higher quality surface.
Prime pillar
Primes the extruder before each layer starts. This is especially useful when using multiple extruders where you want to prime the extruder before printing a layer.
Tool path preview
Very easy to use 2D or 3D toolpath preview.
Check comparison of Kisslicer with other slicers on this link https://groups.google.com/forum/#!to...ot/12F0Iyvoark.