Good deal its been a while since ive used pronterface.Quote:
Originally Posted by Donziboy2
Printable View
Good deal its been a while since ive used pronterface.Quote:
Originally Posted by Donziboy2
But just to clarify, the printer prevents cold extrusion, not Pronterface or other host software. Either the printer firmware has things set to allow cold extrusion, or the printer is receiving an M302 gcode command to enable it. IMO, allowing cold extrusion by default isn't a good idea.Quote:
Originally Posted by flatty_420
Agree with all that. Ask me why... ;-)Quote:
Originally Posted by printbus
We are talking about the manual controls. If your trying to extrude with a cold hotend with everything assembled then you deserve to have to clean up a mess.Quote:
Originally Posted by printbus
Doesn't matter. The printer still shouldn't typically be allowing it. Who knows - maybe pronterface IS sending an M302 when you manipulate the manual controls.Quote:
Originally Posted by Donziboy2
It shows the output I can look when I get home.Quote:
Originally Posted by printbus
I'm on hold yet again waiting for a new stepper driver in the mail. This is becoming very frustrating... I hate waiting for crap in the mail. Makerfarm may be very fast to respond to contact but that is a bag full of fasteners and 3 motor mounts that were not originally in the package and now a defective stepper driver right out of the box. I'm a little disappointed.
A new stepper driver fixed the problem.
PLA
https://www.youtube.com/watch?v=P8EpXTT5T_o
ABS
https://www.youtube.com/watch?v=-FdyTNvZl6E
:cool:........................
I'm pretty impressed by the bridging at the top of the cube..., i.e., the cube appears to have had no infill...