So, the new Raspberry Pi shows up and now I get the following:
Code:
[ 740.499047] usb 1-1.3: new full-speed USB device number 16 using dwc_otg
[ 740.579015] usb 1-1.3: device descriptor read/64, error -32
[ 740.769245] usb 1-1.3: device descriptor read/64, error -32
[ 740.959289] usb 1-1.3: new full-speed USB device number 17 using dwc_otg
[ 741.039028] usb 1-1.3: device descriptor read/64, error -32
[ 741.229015] usb 1-1.3: device descriptor read/64, error -32
[ 741.419004] usb 1-1.3: new full-speed USB device number 18 using dwc_otg
[ 741.838948] usb 1-1.3: device not accepting address 18, error -32
[ 741.919047] usb 1-1.3: new full-speed USB device number 19 using dwc_otg
[ 742.339105] usb 1-1.3: device not accepting address 19, error -32
[ 742.340747] usb 1-1-port3: unable to enumerate USB device
I guess it shorted out the usb chip or something on the board. (I get the same thing from my Mac when I plug it [battery only])
I wanted the rumba so I could use the graphical display and multiple extruders, but now I'm not so sure it was a good idea.
This is very annoying...