No problem. I was always used to # being used to comment out things in Freebsd config files and such so I was confused when I started working with the config files for the printer.
ok I got it working! :) the heatsink i got with it is comicaly huge lol.
oh well this thing wasnt going to win any beauty awards anyways :) ignore the nest of wiresAttachment 7470
I also have mine working and it has been printing for 4 hours with no issues.
I am happy to report printing with PID enabled and with the heat bed off I am getting the same results; in other words no banding.
I am having some problems since implementing the ssr. Not sure if it is that, or the new power supply. I suspect the power supply. Got the 79amp model linked earlier in the thread.
The he issue I am having is the print just stopping. I am running the prints from the sad card. It is like the printer is being momentarily reset. The print just stops and reverts to a state it enters when you first power up.
I havent witnessed this this first hand yet so I am just speculating. I had a few small prints work fine with the ssd before the new power supply was installed. This is why I am leaning towards the new supply being the culprit.
Thanks for the sympathy. He he. I probably cause more problems stumbling around then anything else. Things are much easier to diagnose when there is a pattern. This issue has no pattern I can see. Some print fine, some don't.
My last 8 hour print completed without issue. Looks pretty good. I'll keep printing away and see if I can notice a pattern. Also, the power supply I bought was linked to in a different thread. It is a bit overkill, 75 amp server supply relabeled as a Juice Box from Ebay. I will keep an Eye on it.
Print tonight failed. Gotta to figure this out! I checked all the wires and they look fine. Is there anything in the firmware or code that could cause this? Perhaps the power supply is the culprit.
Yes, it is holding steady at 12.4 during the prints.