Originally Posted by
regpye
I had to change a few things, but this is how it is setup now.
#define Z_RAISE_BEFORE_HOMING 4 // (in mm) Raise Z before homing (G28) for Probe Clearance.
// Be sure you have this distance over your Z_MAX_POS in case
#define XY_TRAVEL_SPEED 8000 // X and Y axis travel speed between probes, in mm/min
#define Z_RAISE_BEFORE_PROBING 10 //How much the extruder will be raised before traveling to the first probing point.
#define Z_RAISE_BETWEEN_PROBINGS 5 //How much the extruder will be raised when traveling from between next probing points
After you made some changes, the positive offset didn't work any more and I had to go back to a negative offset (I don't understand all this)
Anyway it is working fine like this. I wonder what would happen if I tried to use these settings on one of my i3 machines that has a servo?