Perfect!
W, You don't happen to have yellow Ninja-Flex do you?
Printable View
Very nice, I've printed 5 or 6 of these items from this remix (http://www.thingiverse.com/thing:937421) and all the ones I printed were at 30% infill. I have heard other users having issues with the jack but I printed the remixed item and didn't run into any problems.
I tested mine with supporting weight and it held up better than I thought (http://www.thingiverse.com/make:225013). :)
Well? First Ninja Flex with the Flexion's is in the books. Not bad but I think plenty of room for improvement.
Opinions and suggestions welcome!
[IMG]http://i58.photobucket.com/albums/g2...psbryn5ghz.jpg[/IMG]
Printed a 7" x 3.5" x 2" four sided tray (open top and front) with ~2mm wall thickness in ABS. Large area didn't warp off the bed (yea!), but all of the sides warped and cracked (boo!). Re-printed it in Raptor PLA and it's just perfect. One of these days I'm just gonna stop beating my head against that ABS wall.
Ok, I have a roll of black eSun PETG.
What settings for S3D? If anyone getting good prints can fill me in on settings or upload a FFF profile I can check out that would be great.
OK, back to Ninja!
Hmm, ambient here is~25C-26C and ~42% humidity. I have been running the bed at 95C. After about 20min the interior temp usually can get up to about 32C and the humidity drops to ~30-34%. I've not noticed the temp climbing past ~32C and I am wondering what's different. Why does your setup warm up so? Ideas?