230c(ish) for nozzle
75 then drop to 60 for HBP.
Wanna slow it down like ya normally would with PLA....2400-2600mm/min or so is good for most stuff.
Printable View
HELP!!!!
I am trying to print this:
http://www.thingiverse.com/thing:831200
I have got all the parts but 1 printed. The one part I can not get done is 'LH_Green_Cape_body3'.
When sliced in S3D it is missing s big section of the model, making unprintable. Prior to slicing it looks as it should on the plate.
Here how it looks preslice:
http://i1074.photobucket.com/albums/...pskdyfj1q4.png
Here is it sliced:
http://i1074.photobucket.com/albums/...pscfezflt6.png
I can see NO errors in the model. Have even loaded it into Blender and confirmed its 100% manifold and all normals are facing the right way.
Any ideas??
Installed the mount I made to adapt a 1.25" pipe to a 2.25' pipe. This holds my weather station. Simple design but it allows me to level the small pipe in North-South and East-West directions.
You want to see something bad? Look at the bottom brackets - the black one is ABS that came with the Flashforge creator pro and the grayish is Makergeeks black ABS brand new roll. Second roll like this and they are non responsive.
[IMG]http://i58.photobucket.com/albums/g2...psvduilzoc.jpg[/IMG]
They have REALLY improved this site since my last visit.
Last time I was on there tried a few models, and none of them came out good. Infact 2 of the 4 I tried came out worse than when they went in. The main issue was huge amounts of artifacting, even on simple model.
Got that part repaired and it printed ok. Now the fun starts...clean up and prep for paint!