It was a starter kit, and is about $60. Might make some for the stock hot ends for FF and QIDI.
Printable View
https://www.amazon.com/Mold-High-Res.../dp/B00IZNNIU8
Similar to this one?
Ya that is it, some mold release spray is needed also.
So, I was running low on blue tape and while at Lowe's I got some more. I ended up getting Blue Hawk brand, mostly because that was actually available in the widest rolls.
Bad mistake. Stuff barely sticks. I'd recommend against it.
i got some goodies in the mail today :D
http://i76.photobucket.com/albums/j2...psju0svpiv.jpg
All installed and up and running it only took me 7 ours but that was with doing other stuff as well.
Just a little bit of fine tuning to be done but that will have to wait until tomorrow.
I wanted to take photo's so i could show how the install went but i got exited and didn't take any.
Will post pictures of the finished install tomorrow.