What can I do the get rid of the sawtooth edges on the cube?
Printable View
Gawd, it's still going.
Can't wait to see what the final readout is. I'm fairly certain we're at probably 20 hours and we're at 80%.
Problem on the QIDI X-ONE. I was doing a long print and I think the X stepper overheated. The gantry got stuck to one side and was real hard to move. turn the power off then back on and it moves freely but the motor was very hot.
How can I turn down the current to it if that is a good thing to try? It is a Marlin type board I believe. The scripts in S3D are very minimal due to it being a pre-release profile I am testing.
I remember some of you doing this on the Tech-1.
Maybe there is something else I should look at?
Thanks.
I was printing one of these: http://www.thingiverse.com/thing:1065206
I went for maximum size on the Qidi. 25 Hours, 36 minutes. Looks pretty good, I'll get a picture tomorrow.