That manifold filament system kicks ass.
Printable View
Opinion:
I am going to be designing a small box to hold a small solar panel and electronics for a remote temperature sensor. Should I use PLA or ABS for outdoor use? It will get weather and a lot of direct sunlight and a broad range of temperatures. Would asnother material be good?
I am not expecting it to las
What do you think about my Alien print?
I did not design him but did print it on the QIDI Tech-1 with Makergeeks PLA.
This is untouched straight off the bed. He is 60mm tall 70mm from to back and about 40 wide.
[IMG]http://i58.photobucket.com/albums/g2...psqo6wdubn.jpg[/IMG]