jfkansas
tanxx man!!
will post a thread when ill get it..asking for tips!
Printable View
jfkansas
tanxx man!!
will post a thread when ill get it..asking for tips!
https://youtu.be/B2aeI0ENwc8
I Have had a Flashforge Dreamer coming up 2 weeks this Monday
This Problem occured after cancelling a print.
Any Help or advice to rectify the problem would be Appreciated
X endstop cable failure. Common.
Yeah, I did not see a light come on at all..
They are cheap to replace, Im pretty sure the dreamer uses these..
At about $5-$8, buy a few spare just incase..
example
http://www.ebay.com.au/itm/SENSORE-F...rXoj_2NJaEk8Hw
I have just purchased a refurb flashforge creator pro, after a terrible stint with a da vinci 2.0a, and right out of the box the nozzle will dispense filament but when it starts to print anything no filament is dispersed on the bed. The bed has been leveled and I have printed where it was a little tight and also where it has been quite loose. I have also cleaned the nozzle out twice. I am quite confused and havent seen any comments on this particular problem. It would be great if any of you have some information on this subject.
Cheers
sounds like too low a printing temperature.
The thing is it will extrude when heating up and also in preheat mode it will extrude out a continuous stream. It's when it goes to actually print it doesnt extrude at all. Not on the bed or piling up around the nozzle. It seems weird how it would extrude out when heated but immediately after when it goes to print not extrude anything. And the clogging that occurs because of it is unacceptable. I dont know if it is a faulty nozzle or something else.