-
4 Attachment(s)
Attaching Cura 15.04.6 images one With and one without Support Images and the estimating Print time.
Attachment 15513
Attachment 15514
Attachment 15517
Attachment 15516
Printed model took a little longer 1hour 32 minutes Without supports.
Actually I printed it without supports.
As you can see there is little flaws near the Holes on edge of the left side.
I have two of these Used Hictop a 3DP11 12volt and a 3DP12 24volt .
In fact there is another used Hictop on E-Bay too bad I do not need or have space for another 3D Printer.
-
Oh no. Well Roberts_Clif my print time is behind you, sir..
https://imagizer.imageshack.com/v2/xq90/923/l6wIeP.jpg
The item printed out well. I might have been able to get a better surface on the print if I dropped the nozzle temp 5c but no worries. It looks nice..
https://imagizer.imageshack.com/v2/xq90/924/uvpoXZ.jpg
So I am embarassed at this point. Obviously. Hat's off to you and your printer tuning capabilities, buddy. I will now chase what you are doing and identify flaws to fix. And TY for pointing me off in that direction. Mine printed in 1:51 or 111 minutes whereas your printed in 1:38 or 98 minutes. Yours printed 13% faster than mine. So now I reprint..
https://imagizer.imageshack.com/v2/xq90/924/P5cG43.jpg
-
I truly believe that the print times are so close that we both won.
Both of us have figured out how to print the very best in the fastest time.
I wish I could get a faster print time and you probably also want a faster print time.
I can print faster though the models start look not so well and the the layer are not well laminated.
Have even upped the nozzle temp with the printer speed helped a little though still sacrificed the model quality and lamination even printing in a heated enclosure.
I have never had any problems with my current controllers other than the two I killed the stepper motor drivers IC chips on.
Did we loose you EmperorShaohao this was your thread and we still want to help you just got side tracked.