Originally Posted by
catalyst
I have this same printer, and I'm having similar issues. Stefan, did you ever figure it out? Some of my prints come out good, and others are pretty rough. Any time I up the infill, they come out looking pretty rough, though. Should I be able to print ABS at 100% infill without issue?
I also picked up Simplify3D, but the print quality was worse that I was getting with ReplicatorG, so I likely need to fine tune and tweak the settings once I start reading up on it and learning it.
I am also using Microcenter's cheap $15 Filament, so I might grab a roll of something else today to try it out.