dont think heater barrel in hot end the culprit?
Printable View
dont think heater barrel in hot end the culprit?
Surely it's not a good idea to do am upgrade until you've got the basic unit working!!!
Remember good/stock resistance should be 19 ohms Mine reads 0 ohms
Sorry I missed that the resistance of a 50 watt Heater at 24 volts should be about 2 and a bit ohms cold and twice that at ,12volts. If it reads 0 ohms hot the PSU should shut down. Did you measure the resistance hot or cold??.
Sorry I got that all wrong I should have said 12 ohms at 24 volts or a current of 2 amps and 3'ohms at 12 volts must be getting old a silly mistake.
I did when it is not hot the printer is off
Did you also disconnect the heater from the power supply ?
YES The 2 wires were disconnected
LOL I wrote to creality and they are closed for SPRING BREAK for Jan 31 to feb 7 Its 20 degrees here LOL
Tried again "Heating Failed PRINTER HALTED Please Reset"