I started making some cookie cutters for my friend.
Attachment 7677
Printable View
I started making some cookie cutters for my friend.
Attachment 7677
Somewhere else, maybe the new matter website support? they said to email them and they will send you a Cura profile. They sent it to me this afternoon, but I haven't looked at it yet.Quote:
Originally Posted by hsus
Would you mind posting it on a thread here?Quote:
Originally Posted by KMToydarian
http://support.newmatter.com/custome...-faqs/articlesQuote:
Originally Posted by dshapdesign
I wonder if that's caused by the rolling surfaces of the long splines. Gears are a bit "bumpy" so the bed plate probably has a fair bit of vertical vibration as it rolls across them.Quote:
Originally Posted by jamesarm97
James-Its probably being caused by overheating the print. either lower the ambient room temp or reduce hotend/heatbed temp.
I finally got my printer the other day, here's my first "make" on thingiverse: http://www.thingiverse.com/make:174245
https://thingiverse-production-new.s...w_featured.jpg
Details in the post there. Now attempting a bigger print using high detail from astroprint, 14 hrs in looking great - but sloooooow ;)
The last object I printed was a Spooky Jack o Lantern for the last Halloween season! Here it is!
Attachment 7954
Here are a couple of prints, the first one just showcasing the difference between slicer settings, the good one is based off of AstroPrint's best settings but with reduced bottom and top layer heights and 100% infill. I made the model myself.
Attachment 8018
Here's a bigger print I did, using the astroprint best settings but reduced infill due to the large size. Since I've been experiencing the shifting issue with taller prints I opted to print this one lying down with lots of support.
In hindsight I should've printed it lying down at 90 degrees, instead I rotated it to have as little support as possible. This lead to severe striations in the bottom plate.
Should be noted that one of the supports fell over during printing, making the right hand messed up, you can't see it here but the back is messed up. It looked like cotton candy out of the printer but I heated a butter knife and flattened it, it's passable now.
This is my first big print and the first one I post process. I'm printing some sanding tools now. But sanded and applied gesso for a couple of rounds and then spray painted two layers. The glasses are removable and painted with matt acrylic and then sprayed with glossy veneer. Model based off of: http://www.thingiverse.com/thing:1057389
Before and after:
Attachment 8020Attachment 8019
A quick view of my prints
Attachment 8032