Hmm... Getting kids to bed pastie.org or pastebin.com your config so one of us can double check things... Have you set your offset yet?
Printable View
Hmm... Getting kids to bed pastie.org or pastebin.com your config so one of us can double check things... Have you set your offset yet?
Do you mean this line? #define Z_PROBE_OFFSET_FROM_EXTRUDER -4.34
Here is my configuration.h:
http://pastebin.com/pU8i5qB0
Still cant get this Z height to move down to the bed.... Could this be an eeprom issue? Ive read that some people had to disable it to get their ABL working
oh you still have eeprom enabled... yes.. disable it
Ok I gave that a try and it worked but how would I adjust the esteps then?
firmware or gcode
The reason disabling the EEPROM is useful when trying to get Auto Bed Leveling going is because very often it is picking up a bogus Z_PROBE_OFFSET number from the EEPROM. Disabling the EEPROM makes that not happen.
You can re-enable the EEPROM and do a M502 (Revert to default settings) followed by a M500 (store settings to EEPROM). At that point things should behave the same and you can start over riding individual settings.