how about for ooze variables?
Printable View
unless it has an option to start each layer at a random point - like simplify3d - then you'll always get the stitching.
you can leave ooze at 0.1
If the model is perfect tube then it will start always at the same point. This the way it is for now.
What are outcomes now?
Depending of slicer, it the looping can at the same spot over and over again; you cannot change that. You can lessen the appearence by printing slowly, as opposed to traveling speed which is another thing and I won't go into detail since I am not a freak in this setting.
I usually print from 30 to 50mm/s
Depending on customers, z height ranges from .05 to .35mm
Try these settings, and tell me if it has change anything.
Hello!
I have noticed this as well. The fact that we use our prints for test fitting prototypes and the look of them has no value had not caused me to worry about it to much. But I add wondering if you found anything that helped with this. Please share your results! Thanks
picture is gone