-
Hello folks. Hope I can get some newbie assistance here.
I just bought a Monoprice Maker Select V2 which, I am told, is a rebranded version of the Wanhow Duplicator. My problem is trying to set up Cura.
What settings do i use? I attempted to do a "Custom" printer setup and waded through all the (thousands???) of settings but in the end, Cura does not recognize the printer is even plugged into the USB port. I can print from the micro card and the test parts included with the printer pre-installed on the card print OK, but I would really like to print from Cura if possible.
Any help would be appreciated.
Tom
-
I refuse to use my computer to run a print. If the computer updates or shuts down mid-print it's boned.
Just my two cents.
-
Fine, printing from the card is not too terrible.... but Cura setup is kicking my ass. Any assistance there would be appreciated.
Tom
-
That would depend on what your specific symptoms are.
I started out with a default profile, which printed ok, and then tweaked one setting at a time to learn how it affects my material.
-
2 Attachment(s)
Does anybody happen to have the firmware defaults for Marlin firmware for the Duplicator i3 Plus? I am actually looking for optimized versions of the settings beyond Page 25 of the manual.Attachment 10967
Attachment 10966