-
3 Attachment(s)
-
That looks great!. I am sure you have tested it, how does the feeding compare to the regular spool holder?
-
Thanks!
Ah forgot to mention that! It is great, so far has worked for me with no issues for two 1 hr prints. the spool rests on only the small cylinder extruding up from the spoke part in the center so there is almost no friction at all. No bearings necessary.
-
so the bolts and nuts needed are in addition to the ones coming from the LCD panel correct?
-
Yes, all of them are spares from my kit although I'm not sure if others have them as well. At a worst case all the parts could be glued together where new screws were needed.
-
Will be printing this out this weekend! I printed out the top bar for the wider spool holder but forgot to set the infil, and so while it printed pretty good, the inside is hollow and I wonder how well it will hold up. I like your design better.
-
Hey Gmay3, I think you are missing the stl file of the piece that the post/spool holder mounts to.
Also the right side when I sliced it in Cura said it would take 15 minutes to print. When I got it loaded in pronterface, it looks to be missing the fram around the cut outs.
-
1 Attachment(s)
Make a remix of some brackets including items from Clough42
for my fan shrouds for PLAhttp://3dprintboard.com/attachment.p...tid=4458&stc=1
-
gmay now i have to modify that somehow in sketchup to make it taller doe the large display knobs tend to hit the front of the frame.
-