Originally Posted by
spegelius
Nice. Interested to see how the color mixing works. I tried it on my clone cyclops hotend with varying results, at least some PLAs weren't mixing, but resulted in a more 'toothpaste' type extrusion. Apparently PETG should mix better, but I didn't try ir, the hotend had too much issues and I didn't have anough patience with it...
About slicers: for MMU2S I think PrusaSlicer is probably the easiest to start with since it the multi-material support is written MMU2S in mind. S3D is harder to get working, at least on my setup where I need to use post-processing sw to add the actual tool change gcode after slicing.
For color mizing I don't know any slicer that supports it. For my tests I wrote a short python port-processor to add the mixing ratio commands per layer.