Bottom Curling

Attachment 4212

I've had my Creator Pro for a couple of days now ad have run across the same problem multiple times with my raft morphing, melting, or curling. I have played around with the build plate temperatures and even replaced the Kapton Tape but I'm still encountering problems.

Attachment 4213

Quote:

---

Originally Posted by bryson0729

Attachment 4212

I've had my Creator Pro for a couple of days now ad have run across the same problem multiple times with my raft morphing, melting, or curling. I have played around with the build plate temperatures and even replaced the Kapton Tape but I'm still encountering problems.

Attachment 4213

---

120 !! That's too high for ABS and off the charts for PLA . 110 to 112 for ABS.
Recommend you read Geoff's sticky at start of forum.
With thanks.....

Quote:

---

Originally Posted by stevekr2

120 !! That's too high for ABS and off the charts for PLA . 110 to 112 for ABS.
Recommend you read Geoff's sticky at start of forum.
With thanks.....

---

Ditto :) 120c is the issue, way too hot. If you can't get it to stick using lower temperatures use a glue stick and some blue tape.