Is anybody using marlin 1.4 on there 10" i3v? I want to add auto bed leveling but i have been informed that Marlon 1.4 might cause issue with i3v.
Printable View
Is anybody using marlin 1.4 on there 10" i3v? I want to add auto bed leveling but i have been informed that Marlon 1.4 might cause issue with i3v.
I don't think you should be hesitant of switching over... First, you can always reload the existing firmware if there are problems. But the newer Marlin firmware is very solid and not too hard to get going if you have people you can ask questions. (And you do have that....)
Im also looking into this atm, ive only had my printer 2 weeks and the leveling of it every time is driving me crazy
i added this to my z endstop. makes it much easier to get the hot end right were you want it.
http://www.thingiverse.com/thing:437330
nefiwashere - Ive just got it going on mine. i'll be doing a test print tomorrow.
Having an issue with printing @.1
Have abl setup with new Prometheus hot end.
http://youtu.be/nNI6RWWBVEI
This is my first print with this hotend. Have always used the hexagon hotend with very good results but I always printed at .3