When I manually control the motor it works fine. a couple minutes after the print starts it jumps all around. Would it be the motor that is bad?
https://www.youtube.com/watch?v=Ij8IN0S575E
Printable View
When I manually control the motor it works fine. a couple minutes after the print starts it jumps all around. Would it be the motor that is bad?
https://www.youtube.com/watch?v=Ij8IN0S575E
Anyone?? help?
Didn't watch the video... what printer?
Could be x-axis endstop cable. Have a spare?
Are your steps per mm set up correctly?