New Owner Saying Hello

Hello everyone! I am new to 3D printing and just received my Creator Pro today.

I have managed to get it assembled, done some test prints, and then gone on to print 3 or 4 other things to learn how things work.

Using the resources available here and on Youtube made it very easy to get up and running with Slic3r and GPX and I have thus far not even connected the printer to a computer, which seems odd to me, but very convenient. :D

I expect I will have many questions as time goes on, but thus far, I couldn't have asked for a better introduction into 3D printing. I must say the print quality is much better than I expected as well. Thanks again...

Robert

Welcome to the 'club'. You'll find lots of good info here.

Cheers,

John

Thank you John...

Welcome! Post any questions no matter how simple they seem and post all information that you think other might benefit from, regardless of how trivial it may seem