-
Prusa MK3S
A little disappointed in my new Prusa MK3S. It arrived at my door May 5, so I've had about a month and a half. Now I can't print anything because I get mintemp bed error. This happened about 20 hours into a 26 hour print too, so big waste of PETG. If I wiggle the bed cable, the temp drops to 0 then back to room temp, so it's a bad cable on the thermistor. I'm waiting for a response back from Prusa to see if they'll warranty or not, but just disappointing that this happened only 6 weeks in. Prusa is supposed to be one of the best builds, but even my cheapies didn't have issues this soon.
OK vent finished...I'm sure they'll get back to me with a satisfactory response.