First layer hascircles which are not properly filled. Happens only for the first layer.
Printer is similar to ultimaker (original)
Program used: Cura 3.2.1 (3.6 wasn't printing well)
Attachment 12785
Printable View
First layer hascircles which are not properly filled. Happens only for the first layer.
Printer is similar to ultimaker (original)
Program used: Cura 3.2.1 (3.6 wasn't printing well)
Attachment 12785
probably z-heaight too close to the printbed - try raising it by 0.1mm
what are you actually printing ?
happens on pretty much any project (except too small one) , in the middle that's a support structure
so even on square prints you get circles ?
yes, still circles . They even have different diameters.
well I think it's lousy software anyway, so scrap cura and try slic3r or replicator-g with the slic3r engine.
Or do the decent thing and get simplify3d :-)
Octoprint also available, and a bunch of others.
For me cura is the most problematic of them all and given how many people have issues with it - just leave it alone and use something else.