can anyone help out with these two probs I am having, printing in ABS Temp 220, bed 110, S3D slicer,
I feel so close to a decent print yet so far........................................!
I keep getting spiking issues , especially around the support areas of the print?
there are also small holes in the print, could this be shite filamen, i read some where that moisture plays a part? :)
you will also note my dismal Kapton application effort! (but I was having these same problems before the kapton was applied) at least the part sticks now!
Cheers
Anthony
Attachment 7631Attachment 7632