-
"The Huntress" 3D print
Another good way to calibrate your machine.. I found this on thingiverse some time ago and put it aside for when I thought my printer could actually handle it, well didn't turn out too bad I must say..
A fair bit of cleaning up work required, some supports were a bit tricky to remove due to all the small parts. This is being sanded and painted, will post a pic update when its done.
specs.
Build time - 4 hours
Bone white ABS, printed at 70ms/110ms 230c/110c
10%hex infil, 2 shells.
Printed at 0.25mm
http://www.devogeninteractive.com/pi...1_52BEBC93&jpg
http://www.devogeninteractive.com/pi...D_52BEBC93&jpg
http://www.devogeninteractive.com/pi...9_52BEBC93&jpg
Link to thingy..
http://www.thingiverse.com/thing:84315
-
That actually turned out very nicely! Thanks for sharing Geoff!