4 Attachment(s)
Blobbing and Layer Delamination with Creality LD-002R
Good Morning all,
First post so here we go.. :)
I have to issues,
- First picture you see the base on my prints get "Blobbeb", best way I can describe
- Second picture looks like layer delamination, see the squares on the right and top sliding off the print.
These are files sliced with Chitubox, 2 resins used is Anycubic Clear and Monocure 3D Rapid
Both I've gone from 4 seconds per layer up to 12 seconds per layer, 10 base layers with 60-100 seconds cure, both resins do this so I can't imagine it being a resin issue?
But then I can't think what else, levelled the print bed 5 times now, all looks good,
Any ideas??
Thanks!
Dion
Attachment 15879 Attachment 15877 Attachment 15878