-
1 Attachment(s)
Help ! Creality Cr10 Pro
Hi - This is my fourth print following a clicking filament drive problem? I cleared the nozzle, made sure the feed tube was correctly inserted into the hot end. It printed the raft good, I think?, then the deformation started to happen? the nozzle even scrapped across the filament ? Any thoughts as to what is going on? Please see pic attached.
-
Post the filament are you using and at what temperature are you trying to 3D Print.
-
-
I am noticing that raft or not the first layer is patchy, not joined in the direction of print.
-
This could note under extrusion, though your raft is looking good.
Is the print speed or temperature changing during print.
I started with PLA printing a 192C now printing PLA at 208C