-
Slicing Software
Hey!
In the past i have been using the Makerbot software for slicing prints for my Replicator 2. For my other printer i used Slic3r and repetier host. Is it possible to create x3g files for the Replicator with Slic3r? The Replicator seems to not accept .gcode files.
-
Here is a very good link showing how to create x3g files using Slic3r.
http://www.3duniverse.org/2014/01/05...forge-creator/
Here is a video showing how this is done. It's for a Mac but also applies to Windows.
https://www.youtube.com/watch?v=RkMNx0dD2vE
-
Newbie question: is sailfish firmware the same as the standard makerbot firmware?