-
5 Attachment(s)
Rough first few layers!
Hi, thanks for letting me join this forum.I'm very new to 3D printing. I have a flashforge Adventurer 3 printer and whilst when i first used it all was OK but just lately a problem has occurred! I am getting rough edges on the first few layers, I feel sure it's something I have altered but have no idea what. I have attached a picture to show the problem I am getting. If anyone can point me in the right direction I would be most grateful.
-
is that the layer it starts the print from? The bottom layer?
-
-
looks like the nozzle is slightly too close to the print bed.
does the calibration happen automatically or do you have to trigger it ?
looks like it's not calibrated properly.
I'd increase the z-gap by 0.1mm - but not sure how you do it with your slicer software.