Hello guys
In some spots it makes infill (lines) can i fix this
https://imgur.com/xFcmt2ahttps://i.imgur.com/xFcmt2a.png
Printable View
Hello guys
In some spots it makes infill (lines) can i fix this
https://imgur.com/xFcmt2ahttps://i.imgur.com/xFcmt2a.png
it's because the model is not an even thickness all the way round.
so at those points the gap is too narrow for a full extrusion line and the slicer has to fill in that way.
It makes absolutely no difference to the final model - and often that kind of gap fill is stronger than a single extrusion line.
But basically it's down to different wall thicknesses in the actual model.
Thanks allot ! for fast reply !! :)