My 3D Benchy test print did not come out great. I have a printrbot simple metal.
Attachment 10162Attachment 10163Attachment 10161
Do you have any recommendations on how I can make my prints better? Thank you!
Printable View
My 3D Benchy test print did not come out great. I have a printrbot simple metal.
Attachment 10162Attachment 10163Attachment 10161
Do you have any recommendations on how I can make my prints better? Thank you!
Please post a list of the settings settings you used, and what printer,
also don't print in transparent materials, you cant clearly see all the defects :)
As above, please post a link to your slicer setting and that will really help.
However, a few points:
It seems that your Benchy is fairly small and this may affect the quality of the model. (try printing bigger if possible)
Also, your layer height (resolution) seems quite high. I would suggest a layer height of 0.1mm. Or if you want a really detailed model perhaps try 0.05mm layer height.
I can also see your infill lines showing through. Although this is common and probably not something that is very bad, you can fix this by having a thicker wall (try 0.8mm) or asking your slicer to print the wall before the infill.
I hope some of these above points help. With a picture of your settings I might be able to be of more help.
Regards,
3DEX - Great Filament
Here are some pictures.
Attachment 10167Attachment 10168Attachment 10169Attachment 10170Attachment 10171
I can get screenshots of the slicer settings in a minute.
Here are the Cura settings.
Attachment 10172Attachment 10173Attachment 10174
I am using the Printrbot Simple Metal with an X axis upgrade.
your pics of the Cura settings are too small toe read :)
the other pictures looks like the temp is a bit too high, and the has a lot of ringing,you could adjust the jerk settings so the are slower, and try a lower and slower temp
Not entirely sure what you are expecting - but those prints are quite good.
And yep, even i can't read the settings even if I get real close to the monitor :-)