ZCorp310 Printhead Error:1003(0)
Hi, we were doing a test print with the Zcorp310 printer, and encountered a print head error: Error1003(0). The printer was left offline for about six months. When we first ran it early this month, the printer ran for about an hour, but there was no binder coming out. Then we tried replacing the print head with a brand new one, since then we got the 1003(0) error/ (it is a print head error as said in the troubleshoot guide) and the printer never run. The error pops up when we do “purge print head” and also when we “print".
Any suggestion on how to work around this?
Thank you!
[re] zcorp310 printhead error:1003(0)
Hi JSenior, thank you so much for the reply! It's been two weeks already, hope you still see this.
We ordered a brand new Hp11 printhead, inserted and tried to purge it. The error 1003(0) still pops up.
We also did a complete clearing for the fluid system. (bleach solution>distill water>fresh binder) Unfortunately the same error is still there. The problem has got us stuck for a while. Just hope that it is not an issue with the pogo pins.
Before you said the machine may have a hardware problem. Is there any good way to inspect the hardware or a way to check the pogo pins?
Quote:
Originally Posted by
JSenior
The Error 1003 (it may be the first of many that you will experience before getting it to run,) is to do with the electrical connection between the cartridge and the machine. Clean the pogo pins with isopropanol or similar and hope that it sorts the problem. If it doesn't then your machine may have a hardware problem...