Ender 3
How to get better top surface quality , what is the problem here ?
Temp nozzle 200
Profile 0.28
Printable View
Ender 3
How to get better top surface quality , what is the problem here ?
Temp nozzle 200
Profile 0.28
sand paper.. This is not injection molding.. that look rather good, top is never smooth like bottom. You may want to reduce the extrusion multiplier by .01 or .02, looks a little over extruded
Thank You :)
Hi DavaX,
If you use Cura you can switch on "Ironing" in the settings.
It makes the nozzle go over the top layer again with very little filament extruded.
On the negative side it adds to the print time.
Hope this helps,
Andy