I have a prusa i3, it came with an auto bed level sensor, this is a green box with a red light. Where does this plug into the board ?
Printable View
I have a prusa i3, it came with an auto bed level sensor, this is a green box with a red light. Where does this plug into the board ?
It depends upon how you have your printer configured. In Configuration.h you will be looking for Z_MIN_PIN. It might be on that pin unless you have dual Z Min endstops defined.
Nothing setup yet, it's all new to me, trying to install pronterface now, getting no were, can't find a install file