Printable View
Hey, I'm kinda still relatively new to the whole 3d printer thing, but I just got my printer back from the repair shop but when I'm trying out the machine I can't seem to get the extruder to work: I'm pushing the manual controls for it but no spinning. Anyone got any ideas?
Using Repetier Host on a ORD Solutions MH3000R1
W7
Does the extruder can not heat up or the filament can not load ?
basically: have you pre-heated the extruder before trying to feed any plastic through ?
Also you might try the ord forum: https://support.ordsolutions.com/support/discussions
Oh: hey! There we go! Thanks! Yeah, need to preheat the head first. I was trying to find the solution on here too, ORD's is kinda hard for me to navigate for some reason. Thanks a bunch!