Make Your Own Glue to Bond Your 3D Prints Together

Rob, who goes by "northernmenace" on Instructables and Thingiverse, can help you make “the most useful accessory to 3D printing, the Glue." To make your own 3D printing glue, you'll need some nail polish bottles, some acetone you can pick up at the hardware store, and some leftover scrap plastic from previous 3D printing projects. You can read the whole story and get links to the project here: http://3dprint.com/64468/diy-3d-printing-glue/


Below is a look at Rob's setup:
http://3dprint.com/wp-content/upload...OOZ.MEDIUM.jpg

FYI, PLA need not apply. Acetone based. Common knowledge. ABS only.

Seriously ? you think this deserves a headline and thread ?
Must have been a VERY slow day :-)

Yea, thats what I was thinking. Slow news day. Gotta post something.

And you don't actually need to make lots of different colour abs-glue. Just use clear abs filament and one solution works for every colour.