5 Attachment(s)
X400 DIY Special offer kit (buildup)
Hi,
I take the special offer from German Reprap today and I´ll write my buildup steps , fews and meanings here hope to get also imput from you.
Fist the package was a bit Bigger than I expected, it just fits in my car.
Attachment 2518
and it was also not easy to carry
opening and removing all air pads the packaging looks not bad mostly was packed seperatly
Attachment 2519
I put all out to take a look on all parts
Attachment 2520
I think everyone has seen enough printer parts so I´ll not show you all single parts
but 2 point were I find great idea I´ll show you
Attachment 2521
there are 2 good boxes with screws and ever place is labeled cool
after finishing can use it for other parts
what i found after was a surprise,
Attachment 2522
the miiled aluminium kit
ther was no information that this update is in the set
Thats all for today now take a look on the online setup guide and will also take a look on the movie maybe i printout the description
Hopefully can write tomorrow already more about the fist steps
br
Thomas
5 Attachment(s)
Frame / Adjustment / Z axle / Printbed
So I finished checking and readjustemnt of the frame yesterday
Attachment 2547Attachment 2548Attachment 2549
I checked every adge in every direction readjust if neccessary and checked again all until all point were in the right angel and flat to the other profiles.
(The Block is a grinded part with perfect 90° angles and absolut flat a realy helpful tool)
I also insert the spindel holder and spindels
holders plate and the plate themself
Attachment 2550Attachment 2551
2 Point I need to double check today
One screw I destroy ,
Pulley of the spindle so I need to remove it again to change the screw.
and one of the holders plate (sinter parts) has a too small hole so I need to drill it to right size today , ( I propose to check all holes of the sinter parts before sometimes they are a bit to small)
if this is finished I can fix the plate and start the first fine adjustment of the plate position ( make it even to the frame)
so more hopeflully this evening
so far around 5 hours work include preparation not difficult yet,
but you need to work realy correct (special on the frame) to get all in the right angle a third hand would be good (its possible alone but need more time)