The printer is stock and I have an enclosure.
Will this printer reliably print ABS as is? I have a spool of Novamaker filament.
If not, what upgrades, or forget about it on this printer?
I have the magnetic bed. Is there any prep I might need to do? Glue?
What temps work for ABS? I'm seeing 235ºC and 110ºC to start and adjust from there.
What enclosure temps are generated? Is there a limit before things go downhill?
I'm assuming the enclosure port for the power supply should be open a bit to allow PS cooling. A vent to outside will be used.
TIA