Printing cable clips, looks good in the beginning but as it gets higher it goes from bad to worse, whats going on? Thanks.
Printable View
Printing cable clips, looks good in the beginning but as it gets higher it goes from bad to worse, whats going on? Thanks.
Just a suggestion.........
Check your extruder 'e' steps and try ORCA slicer, it has some built in calibration files that you just have to print.
Unfortunately my printer isnt listed in Orca.
Which printer are you using?
Flashforge Guider 2
Perhaps manually transfer the settings from your current slicer into ORCA slicer as a start. bit tedious, but one way to make your own slicer profile.
Also look on YouTube for over and under extrusion problem videos
Thanks for the help