2 Attachment(s)
New FF Creator Pro with "Tool 1 Failure"
Hi guys, I have received a new FF Creator pro...when i have to load the filament, i can load ok on the right extruder and prints absolutely great :)
However when I wanted to load the left, I got the following message "Tool 1 Failre! Temperature reads are failing. Check wiring."
Is this referring to the thermocouple at the underside? one of the wires was loose, so i put it back again but the error still persists.
i have not plugged the creator pro to my computer as i use my SD card and have not had a chance to check the firmware version. would this have any effect?
See the attachment below.
Any help appreciated in advance.
Cheers
Attachment 7746Attachment 7747