terrypin
Technician

We must have our lines crossed somewhere. Could you try it one more time then, as you’ve lost me! Earlier you said you’d never used ‘it’. By...

Thanks CA, good stuff there that I’m looking forward to trying out.

Hi Brian, I'm a beginner too, but your post caught my eye. Firstly, that assembly looks rather easier than my Ender 3 V2 was about six weeks ago;...

Thanks CA. I'm learning by the hour about each of the three main areas of my workflow: OpenSCAD, Cura and Ender 3 V2. One particular aspect of the...

"Your homework - make the box parametric :-)" $fn=50; // Defining the box ExteriorL=100; // Exterior cube, length ExteriorW=40; // Exterior...

Neat! Do you have a photo of it in use?

Thanks CA. I managed to cleanly remove the main Cura support around the rim. But not the much smaller support underneath the little pull tag on top,...

Hi Gambo: Thanks, you were quick off the mark! I realised my mistake shortly after posting and deleted the post ;-)

If you're asking about how to make sure the bottom of your lid will end up right at z=0 on your print bed, there's no issue. Yep, that was it. I...

"So you reckon it doesn;t always work ?" Do you mean OpenScad Customizer? If so: That works consistently for me, but has the limitation I...

Thanks a bunch Kevin, great post! Particularly for that advice about facets. I actually tried to get a deliberately low facet value for the little...

CA: I’m not sure why thingiverse is relevant here, given that my post was about OpenScad’s Customizer?I had a few failures with the thingiverse...

I learned elsewhere that A1: Cura was correct to add support (although it was far more substantial than i'd expected). A2: My code was OK but...

Thanks Gambo. ‘Layer height’ I understand! But I must read up further to grasp other terms I’ve encountered like ‘wall count’, ‘number of...

Many thanks Fritz. Yes, that's the part I'm particularly interested in. From CA's sentence: "if you increase horizontal perimeters in the slicer. it...

See resultant conclusions following my cross-post to the openscad sub-forum in reddit:...

CA, I’m interested in this too so would appreciate some detail of how you do that in Cura please? Can you do it, or something equivalent, in OpenSCAD...

FWIW, looks good to me too. Price seems to have increased significantly since your post. Basic unit = £361 and full 'combo' with turntable and...

Thanks CA, but at the time of posting the Ender 3 V2 seemed to be printing OK. My worry was because I expected trouble because of there being so...

I’m wondering if by ‘decorations’ he meant ‘reinforcements’ or similar

Thanks CA. I could find no text either. The ‘PCB’ does not seem part of the print. Presumably just to show its intended position. If I hear back...

Is this the one you want?https://www.dropbox.com/s/fp6n92wxof32wqv/slic3r-mswin-x86-1-2-9a-stable.zip?raw=1

Thanks both. Sounds easier than I’d expected. We’ll see...