Davidtja
Student
Find latest postsMini Statistics
- Join Date
- 02-14-2021
- Last Activity
- Yesterday 03:12 PM
Recent Visitors
This page has had 335 visits
- Tab Content
- Davidtja's Activity
- About Me
-
Older Activity
-
Yesterday, 02:27 PMHi, Thanks so much for your response and it's considerable detail. I thought £20 was probably a long shot but if you could buy the part it's a...3 replies | 159 view(s) -
02-23-2021, 06:07 AMI've just got a 3d printer (all ok so far). Inevitably a friend has asked me to copy a small plastic light fitting that has melted slightly. I've no...3 replies | 159 view(s)
-
02-17-2021, 08:03 AMDavidtja replied to a thread Moving bed at end of print - Creality CR10S Pro V2 in General 3D Printing DiscussionGreat thanks I wasnt sure whether that would do damage appreciate "practical" response.3 replies | 293 view(s)
-
02-17-2021, 05:25 AMDavidtja started a thread Moving bed at end of print - Creality CR10S Pro V2 in General 3D Printing DiscussionTotal Newbie. I cant find an answer to what I assume is a simple question. At the end of my print the print itself ends up at the back of the printer...3 replies | 293 view(s)
-
02-15-2021, 02:03 PMGreat thanks for advice, i'm learning a little at a time but now i'll add heavy duty foil as well as hairspray to my shopping list! Much...12 replies | 1187 view(s)
-
02-15-2021, 12:32 PMI'm also in Uk (so metric) I'm not actually going by what he said - he was using the feeler gauge (that comes with the printer) which is .2mm...12 replies | 1187 view(s)
-
02-15-2021, 11:41 AMI watched a Youtube video where the guy explained that you use the feeler under the head at each of the corner points so that it just moves in and...12 replies | 1187 view(s)
-
02-15-2021, 06:03 AMThank you so much for your help.12 replies | 1187 view(s)
-
02-14-2021, 08:54 AMI'm a little worried about getting the head too close and damage it - i've usied the .2mm tool and have it so that it moves in and out with a little...12 replies | 1187 view(s)
-
02-14-2021, 08:17 AMHi I am a total newbie and bought the CR10S Pro V2 after numerous reviews suggested it was not only a good starting printer but was also very capable...12 replies | 1187 view(s)
About Davidtja
Basic Information
About Davidtja
- Location:
- United Kingdom
Statistics
Total Posts
- Total Posts
- 10
- Posts Per Day
- 0.84
General Information
- Last Activity
- Yesterday 03:12 PM
- Join Date
- 02-14-2021
Looking for a new 3d printer
02-23-2021, 06:04 PM in 3D Printers (Hardware)