Orrin Kuntz
Student
Find latest postsMini Statistics
- Join Date
- 01-22-2021
- Last Activity
- 02-12-2021 11:03 AM
Recent Visitors
This page has had 618 visits
- Tab Content
- Orrin Kuntz's Activity
- About Me
- Tab Content
-
Older Activity
-
02-03-2021, 07:14 AMI think I finally figured out the problem, which was my nozzle was to small. It has been printing fine since then and I would like to thank everyone...27 replies | 3182 view(s) -
02-01-2021, 01:01 PMThe nozzle is always packed full when I remove it. Is the problem with that possibly?27 replies | 3182 view(s)
-
01-29-2021, 10:53 AMhttps://youtu.be/LVZxEXldPiI27 replies | 3182 view(s)
-
01-28-2021, 08:30 PMhttps://youtu.be/QyMqnTplVgc I could not figure out how to upload a video directly, so here is a link to a video of what is actually happening.27 replies | 3182 view(s)
-
01-27-2021, 02:16 PMWhat percent speed should I be running it at?27 replies | 3182 view(s)
-
01-27-2021, 01:06 PMI realized that during the prints that the fan on the right side of the extruder and the one for the mainboard were not running. Is that a problem?27 replies | 3182 view(s)
-
01-26-2021, 06:18 PMThe cables are fine, and I have bot done anything to the firmware. Is that something that needs done?27 replies | 3182 view(s)
-
01-26-2021, 06:16 PMI am able to push it on through with a little help, and the in able to pull it out while it is still hot. And yes, I have changed the nozzle.27 replies | 3182 view(s)
About Orrin Kuntz
Basic Information
Statistics
Total Posts
- Total Posts
- 12
- Posts Per Day
- 0.36
General Information
- Last Activity
- 02-12-2021 11:03 AM
- Join Date
- 01-22-2021
Looking for a new 3d printer
02-23-2021, 06:04 PM in 3D Printers (Hardware)