Bikeracer2020
Super Moderator
Find latest postsMini Statistics
- Join Date
- 05-07-2020
- Last Activity
- Today 02:15 PM
Recent Visitors
- 3Dspacer,
- BreezeCool,
- curious aardvark,
- Gambo,
- harryjohnson,
- helpinhomework,
- liammmm,
- OcenTane,
- PrintPower
- Tab Content
- Bikeracer2020's Activity
- About Me
- Tab Content
-
Older Activity
-
Yesterday, 10:44 AMIf you post spam in any of the 3D printing categories you will receive a ban and all your posts will be deleted.0 replies | 98 view(s) -
Yesterday, 01:46 AMI have just cleared out literally hundreds of spam posts that cluttered up this part of the 3D printing forum. Anyone posting spam will be banned...0 replies | 89 view(s)
-
07-03-2022, 12:45 AMBikeracer2020 replied to a thread Need help with Anet A3-s printer, z axis doesn't auto home. in General 3D Printing DiscussionThe Qidi slicer version of Cura does have a 'Z' axis option if this helps7 replies | 2522 view(s)
-
06-29-2022, 08:30 AMBikeracer2020 replied to a thread Help with print settings for ASA in General 3D Printing DiscussionTry bed temp around 95C. Drop your speed to 30-35. Slower is better. Preheat chamber with bed for a good 30 mins before starting print. On no...1 replies | 543 view(s)
-
06-29-2022, 03:17 AMI think this is a printer specific problem, it didn't happen with either a Raise 3D E2, or BCN W27 Epsilon. Advice from Qidi is that a different...17 replies | 2958 view(s)
-
06-23-2022, 05:34 AMBikeracer2020 replied to a thread Weird curling problem when printing a thin item in 100% infil in Tips, Tricks and Tech HelpLeveling a bed with a feeler gauge will only tell if the bed is flat, not if it is level to the 'X' and 'Y' axis. If the bed was tilted at 30...3 replies | 622 view(s)
-
06-16-2022, 12:25 AMLook in your slicer settings for where you can hopefully change the global 'Z' axis setting. I think you will have to put a negative input there,...4 replies | 655 view(s)
-
06-16-2022, 12:16 AMI think this is printer specific because a print with holes in it that I did on a different printer does not show the same problem of raised...17 replies | 2958 view(s)
-
06-12-2022, 01:06 AMPrint one of the many leveling tests from Thingiverse or Thangs. Then you will be able to tell if your extruder nozzle is perhaps to high from the...4 replies | 655 view(s)
About Bikeracer2020
Basic Information
Statistics
Total Posts
- Total Posts
- 379
- Posts Per Day
- 0.48
General Information
- Last Activity
- Today 02:15 PM
- Join Date
- 05-07-2020
Free games
Yesterday, 04:27 AM in Off Topic