Bikeracer2020
Super Moderator
Find latest postsMini Statistics
- Join Date
- 05-07-2020
Recent Visitors
- Anamika_Sighal01,
- anonymous-0,
- chennai4night,
- dientuchauanh,
- Ericompton,
- joeanderson,
- lesliemugford,
- liveinsurnaceinfo,
- MyCountryMobile,
- tristan1
- Tab Content
- Bikeracer2020's Activity
- About Me
- Tab Content
-
Older Activity
-
Yesterday, 03:33 AMBikeracer2020 replied to a thread Flashforge Adventurer 3 Pro question in General 3D Printing DiscussionIt could be your nozzle is set too high when the print starts. Try adjusting the 'Z' offset in the SLICER SETTINGS to make the nozzle closer to...2 replies | 173 view(s) -
02-05-2025, 03:16 AMBikeracer2020 replied to a thread Confusion About Print Speed and Max Volumetric Speed (MVS) in Default Profiles in QiDi 3D Printer ForumThis might help..... https://3dprintbeginner.com/bambu-studio-fine-tuning-tips-and-tricks/2 replies | 364 view(s)
-
01-28-2025, 10:45 AMYou could do a cold pull to clear any residual filament from your nozzle, see youtube for a demo of this. You can get lengths of specific nylon...4 replies | 2289 view(s)
-
01-23-2025, 04:01 PMRecommending a printer is a question that gets asked a lot and posters will reply with different opinions frequently based on youtube reviews. ...5 replies | 2286 view(s)
-
01-23-2025, 04:29 AMPossibly under extrusion. If you try Orca slicer there are several calibration tests built into it.2 replies | 2357 view(s)
About Bikeracer2020
Basic Information
Statistics
Total Posts
- Total Posts
- 696
- Posts Per Day
- 0.40
General Information
- Join Date
- 05-07-2020
Confusion About Print Speed and...
02-05-2025, 11:23 AM in QiDi 3D Printer Forum